Castro Valley Temp Power Rentals
Temp power poles, generators and lighting for Castro Valley custom homes, remodels and small commercial jobs, permitted through Alameda County.
Hills, remodels and county permits in Castro Valley
Castro Valley is mostly residential, and much of our work there is custom homes, large remodels and additions. Many lots sit on hillsides with narrow streets and long driveways, so a pole truck may not reach the spot where the service makes sense. We look at access first and plan the pole location around it. Sometimes that means a smaller truck, a hand-dug hole for the pole and a longer cable run to the house.
On a big remodel the house service often comes out for a panel upgrade, and the crew still needs power. A 100A pole near the street or a small generator keeps saws and compressors running. Commercial work along Castro Valley Boulevard is smaller in scale, mostly storefront and restaurant fit-outs that need power for a few weeks.
Castro Valley is unincorporated, so the electrical permit goes to Alameda County, not a city building department. PG&E is the utility. Allow two to four weeks to a live meter in most cases, and longer on a steep lot where the main project has extra review. Winter rain can also slow trench work on clay hillsides, so we try to dig before the wet months when the schedule allows.
Request Equipment Pricing
Castro Valley jobs and what fits them
A pole for a whole-house remodel
When the main panel is replaced, the trades still need outlets. We set a 100A service at the street through our remodel temp services in Castro Valley and pull it once the new panel passes.
A quiet generator for a short gap
On a short outage or a tight lot, a small portable gas unit is often enough. We size it to the tools in use through our small generators for remodel crews, so neighbors are not listening to a big diesel all day.
Cooling during summer framing
Inland canyons warm up faster than the flats near the bay. A spot cooler in the job trailer helps a framing crew through August, through our job trailer AC for hillside sites.
Alameda County permits for Castro Valley
Building and electrical permits for unincorporated Castro Valley go through Alameda County, which runs its own building inspection office. We file there and book the county inspection when the pole is ready.
Hillside lots in Castro Valley can carry slope or drainage conditions on the main building permit. Check with the county on your specific parcel; we plan the pole and any trench around whatever the approval requires.
What Castro Valley jobs usually cost
Most Castro Valley poles are 100A to 200A single-phase and land between $1,800 and $4,500. Steep access, long cable runs or a trench can push a job to the top of that range. After install, the pole rents for about $150 to $400 per month.
- Access for the pole truck on a narrow street
- Length of the run from the PG&E source
- Trenching on a sloped lot
- Rental length on the pole
Castro Valley questions
Who issues the permit in Castro Valley?
Alameda County. Castro Valley is not an incorporated city, so there is no city building department.
Can you get a pole up a steep driveway?
Often, yes. If the truck cannot reach, we set the pole near the street and run cable or conduit up to the work area.
Is a generator cheaper than a pole for a short remodel?
For a job of a few weeks, sometimes. Past a month or so, the pole is usually cheaper once fuel and weekly rent add up.
Equipment we deliver to Castro Valley
Schedule power in Castro Valley
Call 510-961-6012 or send the form and we will line up delivery.